Spray Foam Insulation
Spray foam insulation has been around since 1986. There are numerous pros and cons but in my opinion the pros outweigh the cons. A good installer will insure the right weight and R- value and also insure the material is properly installed in all the right cavities and seams.
Spray Foam is better because when properly installed it provides a complete blanket that encapsulates the entire house. It is best installed in open stud walls with no drywall and if you have a basement the rim joist around the perimeter of the base of the 1st floor should be done as well.
Certain conditions will not allow complete coverage or thickness due to access or obstruction but it is far easier to reach these places with the liquid foam than by stuffing paper covered fiberglass batts in hard to reach places.
Spray foam is also more expensive to install costing approximately .40 per sq ft for open cell and 1.50 per board foot for closed cell. Since a board foot is only 1" thick a 2 X 6 wall would require 5.5 board feet per sq ft of wall area. That would increase the cost to $ 8.25 pr sq ft. Your contractor will offer both with differences explained.
The key to a good spray foam insulation job is the installer him or herself. Make sure you hire an insulation contractor with a proven track record and a good on line reputation.
For help in finding a quality contractor Visit www.hogsdiy.com to download the ebook "The Home Owner's Guide To Successful Remodeling". For $ 7.95 this powerful little manual will guide you through the entire remodeling project from start to finish. Learn to save thousands!






Comments