top of page
Search

How can I tell if a wall is "bearing" or not before removing it?

Jan 4, 2020
2 min read

Normally you can see the bearing points of structural members in the attic, basement, or crawl space below where bearing beams, ceiling, and floor joists will be exposed and visible. If access is restricted using a stud finder will help determine the orientation of the floor or ceiling joists from the finished side. Any wall running perpendicular to the direction of the joist could be bearing but it is possible that another wall beyond in the same orientation could be the actual bearing point. In the picture below you can see the ceiling joist in the room beyond the wall are clearly 90 degrees to the wall in question.

As you can see in this photograph there is deflection in header over the opening in this wall. A legal second story addition was added to this house in the 70s. Once the room was demoed for this kitchen remodel the damage could be seen. The floor had sunk 2-1/2" in 12' from the exterior foundation wall. The plans were stamped and legal and all inspections done. There is no way to know why this was missed.

You can see in this next photo what was necessary to repair. This work was what is called unforeseeable, preexisting hidden condition. Unfortunately this additional work cost the homeowner $ 5,000 to repair. It also required a spot footing and posting down to the basement floor.

The best way to avoid this type of issue is when in doubt, hire and architect to review existing conditions. Most contractors can determine bearing points but it is always best to get a document from a certified architect or engineer before proceeding with any structural work.

To avoid any number of budget busting problems that can arise in any remodeling project visit www.hogsdiy.com Purchase "The Home Owner's Guide To Successful Remodeling". Learn how to save literally thousands of dollars on any remodeling project.

 
 
 

Comments


bottom of page